Jordan Technologies
About Us
Vapor Recovery
Combustion & Incineration
Air Filtration
Emissions
Rental & Parts Department
Service Department
Engineering Services
Enhanced Maintenance Package
Contact Us
Wellhead Compression
Home
Engineering Services


Rental Equipment


Jordan Technologies is pleased to offer a Portable Thermal Oxidizing System for use in destruction of Volatile Organic Compounds (VOC) at terminal loading facilities. This Portable Thermal Oxidizing System is also capable of tank de-gassing operations as well. This summary outlines the various features offered by Jordan Technologies for an enclosed vapor thermal oxidizing system designed for safe, efficient and smokeless operation.

The proposed unit includes the following:

A combustion stack, which is a horizontal carbon steel cylinder lined with ceramic fiber refractory. Included with the combustion stack are the following:

  • Specifically designed burners to prevent flash back
  • Pilot assemblies to ignite the waste gas
  • Assist - air blower
  • Separate quench air blower
  • De-gassing blower, which can be isolated when not in use
  • Detonation arrester with one (1) temperature element
  • High performance butterfly valves, used to "state" the flow of waste gas to the burners
  • Control logic configured around a PLC (programmable logic controller)
  • Temperature management system with automatically adjustable air dampers and control valve to provide the assist gas control. Note that in some cases, assist gas may not be required.
  • Stack temperature recording capabilities where required by the customer or regulatory agencies

The vapor thermal oxidizing unit will b capable of performing, as designed, throughout the entire range of 600 gpm to 7,700 gpm equivalent vapor flow.

The packaged unit is assembled and requires a minimum of setup time and site preparation. A number of equipment items, such as gauges and flexible inlet hose, will be removed from self-contained storage and will be field connected by others. It is generally the responsibility of the customer to provide the supply of natural gas or propane for pilot and assist gas.

The Portable Thermal Oxidizing System also carries a full range of spare parts in order to minimize downtime.

Basis for Design

The Jordan Technologies' Portable Thermal Oxidizing System is designed and based on the following terminal loading characteristics, product characteristics and other design data. The basis for design follows:

Characteristics of the Product Loaded:

Product Loaded------------Gasoline (Consult Jordan Technologies for other VOCs)

Design Vapor Concentration (gasoline) 20%VOC 40%VOC
Vapor Heat Release 40.9MM Btu/hr 40.9MM Btu/hr
Design Flow Rate 7,719gpm maximum 3,924gpm maximum

Utility Requirements:

Electrical Requirements 480 Volt/ 3 Phase/ 60 Hz
Full Load Amperage (at 480 Volt/ 3 Phase/ 60 Hz) 28 Amps (without de-gassing)
80 Amps (with de-gassing, maximum)
Electrical Area Classification for the VCU Non-Classified
Pilot Gas 0.8 scfm @ 7 psig (Natural Gas)
Assist Gas 458 scfm @ 15 psig (Natural Gas) (maximum amount required, based on clean vessel conditions, 7,719 gpm gasoline rate)
Assist Gas 880 scfm @ 15 psig (Natural Gas) maximum - De-gassing (maximum amount required, based on clean tank conditions)


Required Inlet Pressure:

At maximum design flow rate ----12" w.c.

For more information regarding Portable Combustors please contact us.

Untitled

2820 South English Station Road > Louisville, KY 40299 > phone: (502) 267-8344 > fax: (502) 267-8379
info@jordantechnologies.com